ASDSO Dam Safety Toolbox

Inspect Full Length of Pipe

From ASDSO Dam Safety Toolbox
Revision as of 00:10, 2 December 2022 by Grichards (talk | contribs)
Jump to: navigation, search

Message: Careful Inspection is required for CMP, even if the initial impression is good.

Upon initial inspection, a conduit may appear to be in decent condition with many years of service remaining. However, a simple observation at each end of a pipe will not provide enough information to determine the condition of a pipe. A camera inspection of the full length of a pipe will provide more detail and can often be done inexpensively with an action camera such as a GoPro.


Content Courtesy of USDA Decision Analysis Guide for Corrugated Metal Culvert Rehabilitation and Replacement Using Trenchless Technology

  • 24-inch corrugated metal pipe

    24-inch corrugated metal pipe

  • A casual observer would likely assume that this old culvert is fine, but the inspector should look closely to observe the pipe’s condition.

    A casual observer would likely assume that this old culvert is fine, but the inspector should look closely to observe the pipe’s condition.

  • Looking into the outlet using strong light

    Looking into the outlet using strong light

  • Camera (with leg extensions) entering outfall.

    Camera (with leg extensions) entering outfall.

  • Inside the culvert looking upstream using CCTV

    Inside the culvert looking upstream using CCTV

  • Inside the culvert looking upstream, 84 feet from the outfall

    Inside the culvert looking upstream, 84 feet from the outfall


Note: The content on this page was originally created as part of DamOutletWorks.org (DOWL, 2018). It has subsequently been updated and reformatted as part of the Dam Safety Toolbox.
Revision ID: 4671
Revision Date: 12/02/2022

Retrieved from "https://damtoolbox.org/index.php?title=Inspect_Full_Length_of_Pipe&oldid=4671"